General safety instructions
Description of the warning concept, the notations used and a list of the general safety instructions
Warning label concept and spellings used
This manual is an integral part of the MOTOREX DYNCO 2.0 and contains instructions that you must observe for your personal safety and to prevent damage to property. Safety and general safety instructions are labelled as follows:
means that bodily injury can occur if the appropriate precautions are not taken.
means that property damage can occur if the appropriate precautions are not taken.
This symbol is used to describe the individual steps in the menu navigation.
Safety regulations
General
Only use the device in bright, well-lit and well-ventilated rooms.
When transporting and handling the DYNCO 2.0, ensure that there are no objects on the device that could fall off.
The device may only be opened by authorized persons.
Defective fuses must always be replaced by new fuses with equivalent properties.
Do not connect the device to voltages or frequencies that do not correspond to the specifications on the device label.
Do not expose the appliance to a heat source and avoid impacts.
Do not move the device when the power cables are connected.
Do not clean the device with aggressive products that could damage the sheet metal or the touchscreen.
Protect the device from moisture and intense sunlight.
Using the MOTOREX DYNCO 2.0
Keep the material safety data sheets (MSDS) for the products used in an easily accessible place. In the event of an incident, these provide the necessary instructions.
Protect your face, hands, arms and legs from contact with hot vehicle surfaces and hot automatic transmission oil.
Safety goggles are recommended to prevent eye injuries.
Use an exhaust extraction system.
If the noise level exceeds the legally permitted values, wear suitable hearing protection.
Never touch the high-voltage cables in the engine compartment when the engine is running.
Pay attention to the moving devices in the vehicle, e.g. fans, which also work when the ignition is switched off.
Only remain in the safety area while the vehicle is being raised.
Pay attention to routed hoses and cables to avoid tripping.
Any liquid spilled on the floor should be collected as quickly as possible to prevent slipping.
Only use the cables supplied and ensure that they are well insulated.
The wheels of the vehicle must be locked using the parking brake (or selector lever in position "P") or with the aid of a "brake servant".
Do not hold or lean on the lid of the additional container while using the DYNCO 2.0.
Do not leave any tools near or on the battery. This will prevent accidental contact.
Transporting the MOTOREX DYNCO 2.0
When transporting the DYNCO 2.0, the following regulations must be observed:
Observe the locally applicable occupational safety standards (weight approx. 75 kg).
If the device is lifted without technical aids, pay attention to the weight of the DYNCO 2.0 (approx. 75 kg) and a good grip.
Personnel who are not involved in loading/unloading must not be present in the relevant work area.
If the DYNCO 2.0 is transported on a vehicle, the standard load securing regulations and the correct positioning of the DYNCO 2.0 must be observed.
Delivery and installation
Only unload the appliance in accordance with the applicable occupational safety standards (total weight approx. 75 kg).
Ensure that all components and devices are undamaged. If necessary, MOTOREX customer service should be contacted immediately.
Disposal of the MOTOREX DYNCO 2.0
The black line with the symbol of the crossed-out dustbin means that the product was marketed after 13.08.2005 (see 2002/96/EU and DIN EN 50419:2005). Please note that the product is subject to the European Directive 2002/96/EC (RAEE) and the laws applicable in your country for environmentally friendly recycling/disposal.
Last updated