The "Service" menu

Overview of the various menus on the DYNCO 2.0.

Access to the settings

Start / [Page 2] / SERVICE

Setting menus page 1

Settings page 1

OIL TYPE

The OIL TYPE function involves a PRIMING. The two menu functions are therefore described together here.

• Select oil type

• Feed the two DYNCO lines into the waste oil canister.

• Start the flushing program.

For a resistance-free flow, use an open adapter from the red case.

• The "PRIMING" program carries out two line flushes. These must be started individually and take about 15 seconds each.

• At the end of the PRIMING, the completion is acknowledged.

Select oil type

Automatic change to change oil type

Monitoring the oil type change

The following ATFs are stored in the DYNCO 2.0:

Page 1	Page 2	Page 3	Page 4
ATF GENERIC*	ATF STAR 9G	ATF SUPER	CVT FLUID SB
ATF BLUE	ATF MULTI	ATF DEXRON III
ATF JLV	ATF VI HP	ATF J III
ATF STAR 7G	ATF CT8	DCT FLUID MV

ATF GENERIC is a fictitious ATF that can be used if non-MOTOREX ATFs are used.

NEW OIL TARE

The TARE functions are used to calibrate the device and are also used if the canisters supplied by MOTOREX are not used.

• Select the scale that you want to calibrate.

• Make sure that an empty canister is placed on the corresponding scale.

• Confirm by pressing "START".

• Wait for the calibration to complete and then confirm with "OK"

Calibration menus for the three scales of the DYNCO 2.0

Confirm that calibration can begin.

Display, calibration complete.

USED TANK TARE

see NEW OIL TARE

AUXILIARY TARE

see NEW OIL TARE

PRIMING

see OIL TYPE

Use PRIMING for troubleshooting (venting the appliance) or during initial commissioning.

SETTINGS

The following adjustments can be found in the "Settings":

Menu	Settings
Display	Setting the LCD brightness
Audio	Switching click noises on/off
Clean Screen	Calibration of the screen.

When cleaning the screen, do not use any aggressive cleaning agents that could damage the screen.

Setting menus page 2

Settings page 2

DATE / TIME

COUNTERS

LANGUAGE

CONTACT AND SUPPORT

TEST MODE

In TEST MODE, various parameters of the DYNCO 2.0 can be monitored or controlled. This function is also intended to support troubleshooting.

Page 1	The following are tested
Pressure 1	Pressure in line 1 / pressure sensor 1
Pressure 2	Pressure in line 2 / pressure sensor 2
Temperature	Temperature sensor
Battery voltage	Vehicle battery voltage

Page 2	The following are tested
New fluid	Volume of the fresh oil canister
Used fluid	Volume of the waste oil canister
Additive	Volume of the additive tank
Additive valve	Control of the additive valve

Page 3	The following are tested:
New fluid valve	Control of the new oil valve
Used fluid valve	Control of the used oil valve
Low flow valve	Control of the low pressure valve
Pump value	Control of the pump

UPGRADE

Software updates can be carried out using a USB stick and via the control panel. For such updates, you will be instructed accordingly by MOTOREX field service staff or MOTOREX customer service.

The MOTOREX DYNCO 2.0 must be opened for major firmware updates. This type of update is carried out by MOTOREX personnel.